VMProtectBeginUltraLockByKey with Delphi
Posted: Thu Dec 01, 2022 1:10 am
I set a correct Serial in Delphi and before call the locked procedure I confirmed that the Serial is Ok...
I confirmed also, that (VMProtectGetSerialNumberState() returns = SERIAL_STATE_SUCCESS = (0)
Where is the wrong here ???
My code is the below:
if (VMProtectGetSerialNumberState() = SERIAL_STATE_SUCCESS) then
begin
VMProtectBeginUltraLockByKey('LoginClick');
// This is my procedure that must be locked with serial number
ConnectToServer();
VMProtectEnd;
end;
Thank you !
I confirmed also, that (VMProtectGetSerialNumberState() returns = SERIAL_STATE_SUCCESS = (0)
Where is the wrong here ???
My code is the below:
if (VMProtectGetSerialNumberState() = SERIAL_STATE_SUCCESS) then
begin
VMProtectBeginUltraLockByKey('LoginClick');
// This is my procedure that must be locked with serial number
ConnectToServer();
VMProtectEnd;
end;
Thank you !